![]() ![]() If there are none, try driving with the Stabilitrak light on. If the Stabilitrak light is flashing, the first thing you should do is check for new notifications in your vehicle’s Driver Information Center. The service center will display a message if the system isn’t functioning properly. If the repair doesn’t solve the problem, you can reset the StabiliTrak system. You should take your vehicle to a local service center right away. ![]() If the light does not appear, your vehicle needs to be serviced. If you notice the light on your dashboard, it means your Stabilitrak system is malfunctioning. The loss of steering ability can be caused by several problems, including a malfunction in the steering angle sensor. The system relies on sensors to determine the steering wheel and tires’ position and then applies brake pressure to the wheels to correct the vehicle’s balance and direction. If the Service Stabilitrak light is flashing or blinking, your vehicle might be experiencing problems with the Stabilitrak system. It may just be the difference between a safe driving experience and one that leaves you feeling uncomfortable. In oversteering situations, the system applies the outer front brake while understeering engages the inside rear brake. When you are driving, this system sends pumps to each wheel to help keep the car in control. Vehicle started once, ran rough, and struggled to start afterwards.A Chevrolet Equinox with StabiliTrak is equipped with an electronic stability control system.Low oil level (probably an unrelated leak).Low battery voltage (11 volts vs 12.8 - 14.2 volts normally).Check engine light (I'm getting a reader tomorrow to get the code).Vehicle has been sitting for about a month.The only thing I noticed is that the oil was at the min fill line (maybe I have a leak?), but hopefully that wouldn't have caused any damage?Īlso worth noting is that I live in Upstate New York where it has been between 10 - 30 degrees Fahrenheit for the majority of December. I then used the built in battery voltage display while in accessory mode and it read pretty low, about 11 volts (I normally see this between 12.8 - 14.2 volts), but the lights and displays all appeared to be working. While trying to start it the second time the electronics and headlights were much dimmer while trying to start it and flashed quite a bit. I then tried to turn it back on and after 4 - 5 cranks (it usually takes 3) I decided to stop and not put too much strain on the starter. I let it idle for a few seconds, 15 tops, and turned it off. StabiliTrak looked to just be stability control, so I wanted to see if the engine would fire up it did, but the engine ran pretty rough. Today was the first time in awhile it has been nice out, so I go to start it and I have a check engine light and a warning message saying "Service StabiliTrak". The last time I've started it was December 28th and it ran perfectly fine (ran for about 1 minute and moved a few feet to make room in my garage). I have only driven it in my driveway to move things around in my garage. My 2013 Camaro 2LS has been sitting in my garage without being driven daily for about a month now, maybe longer. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |